What a Furnace Replacement Job Involves
We start with the load on the house, not the label on the old furnace. Many homes across the region have a furnace one or two sizes too big because someone matched the last one. We shut down and disconnect the old unit, pull it out, then check the plenum, the flue, the gas piping and the condensate path before the new furnace goes in. Sheet metal transitions get rebuilt where they need it. When the new unit is set, we run it through a full heat cycle and check temperature rise and static pressure.
What We Check and Install
On a replacement we look at the whole air path, because a new furnace pushing through undersized return duct will run hot and short-cycle. We measure static pressure, check filter sizing, and look at the returns. Venting gets inspected end to end, including the termination. We set gas pressure, verify the safety controls, and confirm the thermostat is wired correctly for the equipment, which matters on the mixed gas and heat pump systems common here. If ducts run through a hot attic, we point out sealing and insulation issues while we have access.
How We Decide Replacement Is the Right Call
We look at three things: what failed, how old the furnace is, and whether the failure is likely to repeat. A cracked heat exchanger or a failed inducer on a furnace past fifteen years usually points to replacement. A bad igniter on a ten-year-old unit does not. We tell you when furnace repair is still the better spend, and we say so plainly. If you smell gas, leave the house first, call 911 or your gas utility from outside, then call us.
Other furnace installation work
What every visit includes
You approve a written quote first
Covering 55 cities across Arkansas, Louisiana, Missouri and 4 more.You reach a person, not a menu
Open 7 days, 8:00 AM to 5:00 PM CT.Independent of every manufacturer
Carrier, Trane, Lennox, Goodman and more. We are not an authorized dealer for any of them.Furnace Replacement — quick answers
How long does a furnace replacement take?
Most straight swaps take a day. If we are rebuilding the plenum, correcting venting, or working in a tight mid-century closet, it can run into a second day. We tell you which before we start.
Do I need to replace the AC at the same time?
Not always. If the outdoor unit is sound and the coil matches, we can replace the furnace alone. If both are near the same age, doing them together avoids paying twice for the same sheet metal work.
Can a new furnace use my existing ducts?
Usually yes, but we measure first. Undersized returns and leaky attic runs will make a new furnace run hot and cycle short. We tell you what the duct needs before the new unit goes in.
How it works
- Step 1
Tell us the symptom
Call or fill out the quote form and describe what the system is doing. Warm air, short cycling, water on the floor, a smell, a noise. That detail tells us what parts to load on the truck.
- Step 2
We diagnose on site
A technician checks the thermostat, the electrical side, airflow through the filter and coil, refrigerant behaviour and the ductwork. You hear what we found in plain language before anything gets replaced or repaired.
- Step 3
You approve the fix
We explain the repair, what it costs and what happens if you wait a season. Nothing gets done without your go-ahead, and we tell you honestly when a repair no longer makes sense.
- A real person answers
- Open 7 days
- Written quote before work starts
Why homeowners call us
- We know humid-climate systemsAcross the region the real enemy is moisture. Systems here run long hours pulling water out of the air, and that shows up as frozen coils, clogged drains and mildew smells. We diagnose for humidity, not just temperature.
- Mixed gas and heat pump workPlenty of homes we visit run a heat pump with gas backup, and the two have to hand off cleanly. We troubleshoot both sides, including defrost boards, reversing valves, ignitors and heat exchanger concerns.
- Attic ductwork is our daily breadMid-century homes often have ducts running through attics that hit brutal temperatures. Crushed runs, disconnected boots and leaking joints steal cooling before it reaches the room. We find them instead of blaming the equipment.
- Repair before replaceA capacitor, a contactor, a blower motor or a clogged drain line fixes a lot of the calls we take. We would rather fix what you have and tell you plainly when the numbers stop working.
- All major brands, gas & electricFrom Carrier and Trane to Lennox, Goodman, Rheem and Bryant, serviced independently.
- Straight answersNot worth fixing? We say that out loud, and often it saves you the visit fee.
Furnace Replacement
Ready to book furnace replacement?
Describe the system and your ZIP. The written quote comes before any work.
- A real person answers
- Open 7 days
- Written quotes
- All major brands
- Gas & electric
Rather not call? Get a free quote →
